POWERMUST(8) Network UPS Tools (NUT) POWERMUST(8)
powermust - Driver for Mustek PowerMust series UPS equipment
This man page only documents the hardware-specific features of the pow-
ermust driver. For information about the core driver, see nutupsdrv(8).
The powermust driver is known to work with the following UPSes:
Mustek PowerMust 400VA Plus (12V)
Mustek PowerMust 600VA Plus (12V)
Mustek PowerMust 800VA Pro (12V)
Mustek PowerMust 1000VA Plus (24V)
Mustek PowerMust 1400VA Plus (?V)
Mustek PowerMust 2000VA USB (?V)
OnLite AQUA 50 (12V)
Square One Power QP 1000 (?V)
It may also work with other UPSes in the PowerMust series, but they
haven’t been tested.
This driver does not support any extra settings in the ups.conf(5).
This driver supports some extra commands (see upscmd(8)):
Turn off the load and return when power is back
Turn off the load and remain off
Stop a shutdown in progress
Turn on the load immediately
Turn off the load immediately
Reset minimum and maximum input voltage status
The behavior of the driver can be controlled by some user definable
variables (see upsrw(8)):
Interval to wait after shutdown with delay command (seconds)
Interval to wait before (re)starting the load (seconds)
No known bugs at the moment.
Carlos Rodrigues <firstname.lastname@example.org>
The core driver:
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/
Fri May 14 2004 POWERMUST(8)
Man(1) output converted with